Plate, plastic, sublimation

Plate, plastic, sublimation


Polymer (Plastic) Plate printing by  vacumepress


Print on the folie, Image 1 cm bigger than the plate.

Put the press to 160 degrees Celsius

You already may put the plate into the press without the image

When the press reach the temperature put vacume on without the image for 2 minutes.

Open now the press, plate will be total flat, put off vacume and lay your print on the plate.

Wait 10 seconds and the folie will become softer.

Now push on vacume again for 5 minutes, look before you close the press that the folie will go well as you can easy strike the folie with your fingers.

Plate will come back in his shape when you will take him out of the press